We use cookies to optimize site functionality and provide the best possible experience.
View our new Privacy and Protection of Personal Data here.
Accept Settings
865MHz LoRaWAN EndNode Modem with Modbus TCP/RTU Scheduler with 2 x 10/100Base-T(x) Ports, 1 x RS232 and 1 x RS485 Serial Ports and/or BPL (Broadband Power Line Link)
TLM745
865MHz LoRaWAN EndNode Modem with Modbus TCP/RTU Scheduler with 2 x 10/100Base-T(x) Ports, 1 x RS232 and 1 x RS485 Serial Ports and/or BPL (Broadband Power Line Link)
per one
351.50 USD 370 USD
If you buy less than 5 items you will lose your 5% discount
-    Supports 2 x 10/100Base-T(X) ports + 1 x BPL link
-    Wide Range 3 phase input, 110V–240V/50-60Hz wide range power input
-    Supports up to 30Mbps PHY rate on BPL with Up to 10 hops and 1000 nodes
-    Up to 432 sub-carriers from 2 to 28MHz analog bandwidth on BPL
-    Support LDPC-C FEC with 128-bit AES core on BPL
-    Supports Full/Half-Duplex, auto MDI/MDI-X on each port
-    DHCP Server Capability
-    Supports 1 x RS232 and 1 x RS485 Serial Connection up to 460800 Baud
-    Embedded web interface for ease of use
-    Radio Band Options:
865MHz
IN 865 MHz – India, LoRaWAN RF Communication
-    3 Main Device Functions:
LoRaWAN Modbus TCP Scheduler
LoRaWAN Modbus RTU Scheduler
LoRaWAN Transparent Mode (Transparent bridge between LoRaWAN and TCP/IP or Serial Side)
-    Up to 40 device connection in Modbus TCP or RTU Scheduler modes 
-    Up to 10 device connection in Transparent TCP/IP mode 
-    Definable Modbus Serial Interface for Modbus RTU (RS232 or RS485 usage in same device)
-    Selectable Modbus Function Code, Definable Register Address, Total Register Number, Query Interval and Time Out durations.
-    Built in LoRaWAN payload size check. User can read any data in any interval
-    TLM will automatically split based on Maximum Payload Size allowed
-    Activation Over Air (OTAA) or Activation by Personalization (ABP) Selectable
-    User defined LoRAWAN Port
-    Adaptive Data Rate functionality
-    Selectable Uplink Data Rate
-    Selectable Power Level
-    LoRaWAN Class C and Class A support
-    Easy monitor of transmitted data on web interface
-    Easy to follow Device Status on web interface
-    Easy to follow LoRaWAN packages on web interface 
-    Black List and White List based TCP/IP connection filter in transparent mode
-    Firmware Upgrade over Web
-    2 firmware storage capability on same device (1 active only)
-    Wide operating temperature range from -40 to 85 °C
-    Rugged Metal IP-40 housing design
-    DIN-Rail mounting
TECHNOLOGY
LoRa TECHNOLOGY
Based on
STM32L151CxU6Axx 
Pre-Certified according to EN 300 220 
Sensitivity
Down to -138 dBm
Link Budget
Up to 156 dB
Communication Distance 

Up to 15km (Line of Sight)

Typical Communication Distance Indoor/Urban
>2km
LoRaWAN Activation Options
Activation Over Air (OTAA)
Activation by Personalization (ABP)
User Selectable
LoRaWAN Port
User Selectable
Adaptive Data Rate
Available
Uplink Data Rate
SF12 / 125 kHz / 250 bps
SF11 / 125 kHz / 440 bps
SF10 / 125 kHz / 980 bps
SF9 / 125 kHz / 1760 bps
SF8 / 125 kHz / 3125 bps
SF7 / 125 kHz / 5470 bps
FSK 50k / NA / 50000 bps
Tx Power Level
0 to 22dBm Configurable
LoraWAN Class
Class A
Class C

BPL (BROADBAND POWERLINE) TECHNOLOGY
PHY Data Rate
Up to 240 MHz
MAC Layer Protocol
CSMA/CA
Modulation Technology
OFDM-432
VLAN
IEEE802.1q/ IEEE802.1p/ IEEE802.3d
ETHERNET SWITCH TECHNOLOGY
Ethernet Standards
IEEE 802.3 for 10Base-T
IEEE 802.3u for 100Base-T(X)
IEEE 802.3x Flow Control
Mac Table
1K MAC address entry
Processing
Store-and-Forward
Memory
448K bits packet buffer memory


MODBUS CHARACTERISTICS
Modbus Protocol
Modbus TCP or RTU
Selectable by User
Modbus Devices
Up to 40 Modbus command can be defined by User
Modbus Address
Independently selectable by User
Modbus Function Code

Read Coil Status (FC=01)
Read Input Status (FC=02)
Read Holding Registers (FC=03)
Read Input Registers (FC=04)
Selectable
Modbus Command Setting
Register Adress
Total Number of Registers
Query Interval
Time Out 
Independently Selectable for each command
Modbus RTU Serial Settings
Serial interface RS232 or RS485
Serial data settings and Baud Rate
Independently Selectable for each command


CONNECTORS AND PORTS
SMA Antenna Connector for LoRa
1 Standard SMA female interface, 50 ohm
Console Port
USB Type-C or Micro USB connection for LOG in 115200 baud
10/100T(X) RJ45 Ports
Ethernet Connection on 2 ports
Serial Ports
5 pin wired Terminal Connection
Tx, Rx, GND for RS232
A, B and GND for RS485
Reset Buttons
Reset to Client and Reset to Server Operating modes buttons


LED INDICATORS
Power indicator
Power LED
10/100T(X) Indicators
Activity LEDs:
ETH1, ETH2 and TLM (Activity of device itself)
System Indicators
Status LED,
Tx and Rx of data LEDs and Server LED
(LED ON: Server Operating Mode, LED OFF: Client Operating Mode)
Console Indicators
Tx and Rx of data LEDs
BPL LEDs
-BPL Activity
-BPL Link
-Master Indication (LED ON: Master, LED OFF: Slave)


POWER
Input Range
3 phase input, 110V–240V/50-60Hz
Power and Data
AC Power supply use L1-N only. Phase 2-3 connections are used to BPL signal transmission.


PHYSICAL AND ENVIRONMENTAL CHARACTERISTICS
Enclosure
Metal, IP 40
Dimensions
43 x 95 x 124 (w x d x h) mm
Weight 
~400gr
Storage Temperature
-65 to 150 °C
Operating Temperature
-40 to 85 °C 
Operating Humidity
5% to 95%Non-condensing


TLM745: 865MHz LoRaWAN EndNode Modem with Modbus TCP/RTU Scheduler, 2x 10/100 T(x) ETH ports + 1 x BPL (Broadband Power Line) Link, 1 x RS232 & 1 x RS485, 3 Phase AC Power Input, 110V–240V/50-60Hz

BSB Series Industrial Unmanaged Ethernet Switch
BSB Series Industrial Unmanaged Ethernet Switch
TLM Series LoRa and LoRaWAN Modems
TLM Series LoRa and LoRaWAN Modems
LKM Series Electricity Meter Protocol to Modbus Protocol Gateways
LKM Series Electricity Meter Protocol to Modbus Protocol Gateways
CKL Series Modbus, Serial to Ethernet Gateway
CKL Series Modbus, Serial to Ethernet Gateway
STG Series WMBus (Wireless MBus) - Modbus TCP/RTU Gateway
STG Series WMBus (Wireless MBus) - Modbus TCP/RTU Gateway
HUR Series Modbus TCP and RTU Remote I/O Devices
HUR Series Modbus TCP and RTU Remote I/O Devices
MBC Series IEC62056-21 Protocol Auto Baud Changer
MBC Series IEC62056-21 Protocol Auto Baud Changer
KMK Series Optical Probes for Energy Meters
REDZ Software Solutions