- Supports 2 x 10/100Base-T(X) ports
- Supports Full/Half-Duplex, auto MDI/MDI-X on each port
- Supports 1 x RS232 and 1 x RS485 Serial Connection up to 921600 Baud
- Embedded web interface for ease of use
- Instant switch between Server-Client Operating Modes with buttons
- Up to 10 client connection in Server Mode
- DHCP Server Capability
- Easy to follow Device Status on web interface
- 868MHz LoRa based Radio Frequency (RF) Communication
- 128 bit AES Encryption and Decryption on over the air communication
- LoRa or FSK Selectable Modulation Options
- LoRa Rx Group Address and Device Address Configurable
- LoRa Tx Group Address and Device Address Configurable
- LoRa Signal Bandwidth Configurable: 125, 250, 500 kHz
- LoRa Radio Power Configurable between 5dBm (~3mW) to 20dBm (100mW)
- Easy to follow LoRa data packages on web interface
- Black List and White List based LoRa package filter
- Firmware Upgrade over Web
- 2 firmware storage capability on same device (1 active only)
- 90 - 265V AC (100 – 370V DC), 47Hz to 63Hz AC wide range power input
- Wide operating temperature range from -25 to 70 °C
- Rugged Metal IP-40 housing design
- DIN-Rail mounting
TECHNOLOGY
LoRa TECHNOLOGY
Based on
STM32L151CxU6Axx
Pre-Certified according to EN 300 220
Sensitivity
Down to -138 dBm
Output Power level
Up to 20dBm
Link Budget
Up to 156 dB
Communication Distance
Up to 15km (Line of Sight)
Typical Communication Distance Indoor/Urban
>2km
Frequency Range
Min 863Mhz, Max 870MHz
ETHERNET SWITCH TECHNOLOGY
Ethernet Standards
IEEE 802.3 for 10Base-T
IEEE 802.3u for 100Base-T(X)
IEEE 802.3x Flow Control
Mac Table
1K MAC address entry
Processing
Store-and-Forward
Memory
448K bits packet buffer memory
CONNECTORS AND PORTS
SMA Antenna Connector for LoRa
1 Standard SMA female interface, 50 ohm
Console Port
Micro USB connection for LOG in 115200 baud
10/100T(X) RJ45 Ports
Ethernet Connection on 2 ports
Serial Ports
5 pin wired Terminal Connection
Tx, Rx, GND for RS232
A, B and GND for RS485
Reset Buttons
Reset to Client and Reset to Server Operating modes buttons
LED INDICATORS
Power indicator
Power LED
10/100T(X) Indicators
Activity LEDs:
ETH1, ETH2 and TLM (Activity of device itself)
System Indicators
Status LED,
Tx and Rx of data LEDs and Server LED
(LED ON: Server Operating Mode, LED OFF: Client Operating Mode)
LoRa Indicators
Alive (Blinks during normal operation), Tx and Rx of data LEDs
Console Indicators
Tx and Rx of data LEDs
POWER
Input Range
90 - 265V AC (100 – 370V DC), 47Hz to 63Hz AC input
Isolation
Fully Isolated >4200Vrms, 5mA 1 Min
Insulation: Class II
PHYSICAL AND ENVIRONMENTAL CHARACTERISTICS
Enclosure
Metal, IP 40
Dimensions
43 x 95 x 124 (w x d x h) mm
Weight
~400gr
Storage Temperature
-40 to 105 °C
Operating Temperature
-25 to 70 °C
Operating Humidity
5% to 95%Non-condensing
TLM254: 868MHz LoRa Radio Modem, 2x 10/100 T(x) ETH ports, 1 x RS232 & 1 x RS485, 90 - 265V AC (100 – 370V DC), 47Hz to 63Hz AC Power Input
